Go Back
Print

Easy Oversized Christmas Wreath DIY (with Pool Noodles!)

Ingredients

  • pool noodles (at least 4)
  • duct or packing tape
  • garlands of your choice (I used 7)
  • ornaments
  • large bow
  • floral wire
  • wire cutters

Instructions

  • First, I took two noodles and simply taped the ends together to make a circle.
  • Then, I cut two more noodles a little smaller to fit within that larger circle and had their ends situated in between the taped ends on the larger circle (so if the larger circles ends are at 12:00 and 6:00 on a clock face, the smaller circle ends should be at the 9:00 and 3:00 positions). You want to position the ends this way so your circle is more round and you have even pressure pushing out from the middle.
  • Then, I taped the larger and smaller circles together so they formed one frame. For a thicker wreath, you could keep going and add a third inner layer if you like! I used packing tape for this and it worked well enough, but I think next year I’ll use duct tape for a little stronger bond (but packing tape will come off easier if you are planning to use the noodles in the pool during the summer).
  • Once I had my frame I simply tucked the start of my garland into the crack between the two noodles and started wrapping! I would connect one garland to the next with a small piece of wire that I tied through both ends, but you could also staple them together.
  • Wrap all the way around your frame with as many garlands as needed (this will vary depending on the size of your frame and the thickness of your garland) and you can either tuck the final end in between the noodles or tie it with some wire to another garland at the beginning.
  • Now that your wreath is covered, you can either just tie on a bow with some wire or you can add some ornaments like I did! I would cut some wire that was long enough to go all the way around the wreath (with a little extra) and then I twisted an ornament in the middle of the wire. Then I just wrapped the wire around the back of the wreath so I could twist it tight on the back side and the ornament remains on the front side of the wreath. Keep attaching as many ornaments as you want until you like the look of it!
  • When it’s time to hang your wreath, cut another few pieces of wire that are long enough to go around the wreath and twist a small loop into the middle of your wire (this loop is what you’ll hang on your nail on the wall). Use a decently thick wire for this part so the weight of the wreath doesn’t pull the tie apart once hung. Tie the wire around your wreath so that the loop is on the back of your wreath for hanging on a nail.
    Depending on how many ornaments you used and the size of your wreath, you may need just one of these hangers at the top, or you may want one at the bottom as well to support the bottom of the wreath (remember, it’s just a pool noodle frame rather than a stiff wire frame so it may need a little help!). I hung mine with a top and bottom one and then added two more wires in the 2:00 and 10:00 positions since I added a ton of ornaments. I found it helpful to hang the top nail and have another pair of hands help you hold it in place so you can gauge where the other nails need to go for hanging the other spots.
    Once your wreath is hung, stand back and admire your creation!!